Most buyers specify the paint first and then look for a machine to put it down. That order is backwards. On a marking project the machine decides three things the paint cannot recover from: the thickness band it can hold, the amount of bead that survives embedment, and the metres you can finish inside a closure window. A premium thermoplastic laid at 1.2 mm by a worn screed performs like a cheap one.
Kettle and screed (thermoplastic). A 100 kg LPG-heated kettle with a straight-line drawing shoe is the workhorse for edge lines, centre lines and urban work. The shoe sets thickness mechanically, typically 1.5–3 mm, and glass beads are dropped on immediately behind the shoe. Output is governed by kettle capacity, not by walking speed: at 150 mm wide and 2 mm thick, a line consumes roughly 0.6 kg per metre (thermoplastic at about 2.0 g/cm³), so a 100 kg fill covers around 165 m before refilling. Two kettles on a trailer is usually a better investment than one bigger kettle.
Hot-melt spray. Where thickness uniformity matters more than texture — airport aprons, parking deck ramps, factory floors, toll plazas — spraying gives a more even film at 1.5–2.5 mm and lets you cover large flat areas without screed drag marks. Spray also handles stencils, arrows and hatched areas that a shoe cannot follow.
Cold spray airless. No kettle, no heat, no premix melt. A hydraulic plunger pump at 21 MPa (about 3,000 psi) delivering 12 L/min, or a 72 V electric unit, or a small battery machine for kerb lines and car parks. Film is much thinner — typically 300–500 μm — so cold systems are specified for repainting, low-traffic roads, parking areas and temporary works, or two passes where higher build is demanded.
![]()
Contractors routinely over-buy pump capacity and under-buy support equipment. Work the arithmetic backwards from the closure.
Take 12 km of 150 mm edge line in a 4-hour night window — about 3.5 productive hours after setting up and sweeping. That is roughly 3,400 m/h. A kettle machine at 165 m per fill needs a refill every three minutes; even with a fast melt kettle that is not a one-machine job. Three machines with two kettles each, or a hot-melt spray unit fed from a pre-melt tanker, is the realistic configuration. For cold spray the same 12 km is pump-feasible in a single pass, but the practical limit becomes traffic control and the number of operators walking the line.
The lesson: buy output in the unit that actually binds your project — kettle cycles, melt rate, or crew, not headline L/min.
![]()
Give four numbers and the machine choice becomes straightforward: line width, required thickness, metres per closure, and surface type. Everything else — pump pressure, kettle size, bead rate — follows from those.
Tell us your line width, thickness and metres per night, and we will match a machine configuration to the closure you actually have.